المجلة الدولية للعلوم والتقنية

International Science and Technology Journal

ISSN: 2519-9854 (Online)

ISSN: 2519-9846 (Print)

DOI: www.doi.org/10.62341/ISTJ

مجلة علمية محكّمة تهتم بنشر البحوث والدراسات في مجال العلوم التطبيقية، تصدر دورياً تحت إشراف نخبة من الأساتذة

FREEZE-THAW AND SULFATE RESISTANCE OF GEOPOLYMER MORTAR MADE OF WASTE MATERIAL

الملخص
تهدف هذه الدراسة التجريبية التحقيق في مدى مقاومة عجنة الجيوبوليمر عند غمرها في محلول الكبريتات المغنيسيوم لمدة (3 أشهر) و كذلك دورات التجميد و الذوبان حتى (150 دورة). تم استخدام النفايات كمواد أساسية لإنتاج عجنة الجيوبوليمر و تم اختيار ثلاثة أنواع من مواد النفايات المثمثلة في ( الخبث والرماد المتطاير و مسحوق الزجاج) والتي يمكن تنشيطهما جميعًا باستخدام عامل قلوي المثمثل في هيدروكسيد الصوديوم بتركيز ( 12مولاري) و سيليكات الصوديوم و النسبة بينهما 1:1 و تم إختيار نوعان من المعالجة و هما المغالجة بالبخار و الغمر في المياه و دراسة الحواص الميكانيكية لعجنة الجيوبوليمر. تشير النتائج إلى أن قيمة مقاومة الانضغاط لجميع العينات كانت أعلى من القيم التي تم الحصول عليها للعينات التي لم تخضع لدورات التجميد و الذوبان ما عد العينات التي تحتوي على (الخبث و مسحوق الزجاج). يمكن القول ان عجنة الجيوبوليمر التي تحتوي على الرماد المتطاير لها مقاومة عالية لدورات التجمد و الذوابان التي تمت معالجتها بالغمر بالمياه. . بالإضافة إلى ذلك ، تُظهر جميع هذه العينات مستويات عالية من المقاومة للغمر في كبريتات المغنيسيوم مع أن قيم مقاومة الانضغاط تحت المعالجة بالغمر بالمياه كانت أعلى من تلك التي تمت معالجتها بالبخار.
Abstract
The aim of the present experimental study is to investigate the resistance of little cementitious value-based geopolymer mortars subjected to sulfate resistance (3 months) and freeze-thaw cycles (150 cycles). Waste material was used as the base material to produce geopolymer mortar. Three types of waste material, namely Slag (GGBFS), fly ash (FA) and glass powder (GP), all of which can be activated with an alkali agent, were selected to study the effect of the steam-cured (SC) and water-cured (WC) methods on the mechanical proporties of the geopolymer mortar with a constant concentration (12M) of sodium hydroxide. Upon the analysis of the modulus of sodium silicate (Na2Si03/NaOH = 1) and the different proportions amounts of geopolymer in these three materials - GGBFS, FA, and GP – the results indicate that the compressive strength value of all specimens was higher than the values obtained for them once not subjected to any freeze-thaw resistance test, except for those containing GGBS and GP. It can be inferred that the investigated geopolymer FA materials possess an highly acceptable freeze resistance under water-cured conditions. In addition, all these specimens exhibit high levels of resistance to magnesium sulfate immersion and again their compressive strength values under WC conditions are found to be higher than those under SC settings.